SOMATIC EMBRYOGENESIS: AN EFFICIENT ALTERNATIVE TO CONVENTIONAL TISSUE CULTURE (AXILLARY METHOD) METHOD IN BAMBUSA BALCOOA
DOI:
https://doi.org/10.4238/qw8vyb55Keywords:
Bambusa balcooa, Somatic embryogenesis, Tissue culture, Embryogenic callus, In-vitro regeneration, MicropropagationAbstract
The present investigation was undertaken to develop and optimize an efficient somatic embryogenesis (SE) system for large-scale multiplication of Bambusa balcooa and to compare its regeneration efficiency and subsequent growth performance with the conventional tissue culture (axillary method) method. Newly emerged in-vitro shoots (10–14 days old) were used as explants for somatic embryogenesis, whereas newly emerged culms (3–4 months old) were utilized for conventional axillary propagation. Somatic embryogenesis was successfully induced using Murashige and Skoog (MS) medium supplemented with 3 mg L⁻¹ 2,4-D, 2 mg L⁻¹ kinetin and 250 mg L⁻¹ polyvinylpyrrolidone (PVP). Embryogenic callus formation was observed at 28 days, followed by globular and heart-shaped embryo development and embryo germination at 52 days. The regenerated cultures were subsequently multiplied through liquid MS medium supplemented with 2 mg L⁻¹ BAP. Comparative in-vitro monitoring revealed that somatic embryogenesis produced a maximum of 430 shoots, compared with 180 shoots through conventional tissue culture (axillary method) method. Earlier root development was observed in SE-derived plantlets (130 days) than in axillary derived plantlets (145 days). Furthermore, 420 plantlets were obtained at the rooting stage through somatic embryogenesis compared with 170 through the axillary method. Following hardening, 416 plants survived through somatic embryogenesis, whereas 165 plants survived through conventional axillary propagation, representing approximately 2.5-times more plant production. Comparative evaluation of six-month-old hardened plants revealed no statistically significant differences (p > 0.05) between the two regeneration methods for any of the seven evaluated growth parameters, including plant height, number of culms, culm thickness, number of nodes, internodal length, leaf length and leaf width These results highlight the potential of the developed somatic embryogenesis method for large scale commercial micropropagation and mass production of B. balcooa planting material by showing that it offers superior multiplication efficiency while maintaining comparable growth performance to conventionally regenerated plants.
Downloads
Published
Issue
Section
License

This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

